Using service tcp-keepalives to Avoid Hung Telnet SessionsPrintable Pdf
Please provide your feedback on this document.
Prerequisites Before You Begin
Requirements
Components Used
Conventions Background Related Information
Prerequisites
This document explains how to use service tcp-keepalives to clear hung telnet sessions.
Before You Begin
Requirements
There are no specific prerequisites for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information presented in this document was created from devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If you are working in a live
network, ensure that you understand the potential impact of any command before using it.
Conventions
For more information on document conventions, see the Cisco Technical Tips Conventions.
Background
This topology allows for a remote terminal user to gain access to a server across a network using an
autocommand telnet in the configuration of Router 2.
If, however, Router 2 is reloaded for any reason, the terminal will not be able to get back into the server. Upon
attempting to activate the connection, the user will see a "Connection refused by remote host" message. This
message appears because the server believes that the previous telnet session is still connected, thus blocking a
new session.
This situation could be remedied by a network administrator by issuing the clear line command on Router 1,
but this approach has two major shortcomings:
Network administrators may be unavailable to clear the line when needed.
For security reasons, the enable password command is not likely to be given out to users.
One solution is for Router 1 to clear the TTY line when the connection to Router 2 is lost for any reason. TCP
keepalives can resolve this problem. Turn on TCP keepalives on both routers so that one router will notice
when the connection to the other router goes away; otherwise, the far end has no way to know that a reboot or
other connection loss has happened.
To enable TCP keepalives on the routers, use the following configuration commands:
Router1# config term
Router1(config)# service tcp-keepalives-in
Router1(config)# service tcp-keepalives-out
Router1(config)# end
